Inner Range · Licence 332956C

Inner Range alarm installation

Inner Range is an Australian manufacturer whose systems are often chosen where an alarm needs to do more: multiple areas, many users, and door access control tied in. We install Inner Range systems for larger homes and small commercial sites.

Call 0421 772 661 to discuss your site. Floor plans, or photos of each entry, help us scope the job.

Read what customers wrote, below
  • Licensed electrician, NSW 332956C
  • Based in Hurlstone Park
  • Written quote before work starts
Inner Range

Inner Range Alarm system installation.

Inner Range is best known for integrated security systems used in offices, shops and multi-tenant buildings, and those same capabilities suit bigger homes, home offices and mixed-use properties. Rather than a simple alarm with a keypad, an Inner Range system can combine intrusion detection with card or fob access to doors, different permissions for different people and separate areas armed independently.

That extra capability means more planning. Expansion modules, door controllers and power supplies are typically distributed around the building and connected on a data bus, so the cabling design matters from the start. It's a system that rewards a careful layout rather than a quick fit-out.

Blue Link Electrical is a licensed electrician based in Hurlstone Park. We hold NSW Security Licence S00014414 and Electrical Contractor Licence 332956C, so we can handle both the security side and the power circuits a larger system needs, across the Inner West and Sydney.

Know your model

Is Inner Range the right fit?

For a typical two- or three-bedroom house with a front and back door, an Inner Range system is usually more than you need. It comes into its own when there are several areas to manage (a shopfront with a residence behind, a home with a detached studio, a small office with staff), or when you want door access control alongside the alarm. Inner Range's platforms are generally configured with software rather than purely from a keypad.

Because these systems can grow over time, it's sensible to plan cable runs and controller locations for where you might end up, not just day one. Ask about module capacity, licensing of features and how the system will be managed day to day before you decide.

Before we install

What the installation needs.

!

Power for each module

The main controller and remote modules each need a reliable supply and backup battery. Larger layouts may need extra power supplies placed along the system.

!

Bus and detector cabling

Modules connect on a data bus, and detectors wire back to the nearest module. We plan routes so the system is serviceable later.

!

Door hardware

Access-controlled doors need an electric strike or lock, a reader and a way to exit. Door hardware choice depends on the door and frame.

!

Network connection

Remote management and app access rely on a network connection at the controller. A dedicated data point is the tidy way to do it.

!

Keypads and readers

Positioned where people actually enter, at a sensible height and out of the weather where possible.

!

Switchboard space

A dedicated circuit for the security equipment avoids it being switched off with other loads. See switchboard upgrades if your board is full.

How it works

How we install it.

1. Scope and design. We work out areas, users, entries and any access-controlled doors, then lay out controller and module positions and cable routes. You receive a written quote.

2. Rough-in. Bus cabling, detector cabling, door hardware cabling and any new power circuits are run, ideally before linings go up if you're renovating.

3. Fit-off and configuration. Controllers, modules, power supplies, batteries, detectors, keypads and readers are installed, then areas, schedules and user permissions are configured.

4. Commissioning. Every input and door is tested, battery backup is checked and the circuits are tested to AS/NZS 3000, with a Certificate of Compliance for the electrical work. We take you through day-to-day use.

Common problems

Common Inner Range problems.

!

Module offline

A remote module dropping off the bus is often a power supply issue at that module or a cabling fault. Checking voltages along the bus usually finds it.

!

Door not releasing

Can be the strike, its power supply or the door alignment rather than the controller. We check the hardware first.

!

Batteries low across the system

With several power supplies, batteries age at different rates. Replacing them on a schedule avoids surprise faults.

!

Panel losing power

Shared circuits get switched off or trip with other appliances. See alarm panel no power.

Questions

Inner Range Alarm system: common questions.

Is Inner Range suitable for a house?

It can be, especially larger homes, homes with a studio or office, or where you want access control. For a simple house alarm, a smaller panel is often a better fit.

Can Inner Range control door access?

Yes, access control is one of the main reasons people choose it. Each controlled door needs a reader, a locking device and an exit method.

Can it be managed remotely?

With a network connection and the right configuration, these systems can typically be managed remotely. Check which features your chosen package includes.

Do you provide monitoring?

No. We install and configure the system; monitoring is a service from a monitoring company.

What licences do you hold?

NSW Security Licence S00014414 and NSW Electrical Contractor Licence 332956C. We're fully insured.

More

Related brands and services.

Other brands we install
Related services and guides
Areas

Need a Inner Range alarm system installed?

0421 772 661

NSW Electrical Contractor Licence 332956C · Fully insured · Since 2016 · Based in Hurlstone Park

Google reviews

What customers wrote

Excellent electrician Blue Link Electrical was honest, knowledgeable, and took the time to answer my questions The work was completed quickly without rushing and everything works perfectly Will be using them
Parveen EjazGoogle review · Marrickville
Very professional and reliable service. Blue Link Electrical were punctual, friendly, and knew exactly what they were doing. The job was completed to a high standard and the place was left clean. Highly recommend to anyone needing electrical work.
Ablish MughalGoogle review · Marrickville
Can't fault the service from Blue Link Electrical From first contact to job completion everything was smooth and professional Quality workmanship and great attention to detail. One of the best trades experiences I've had. Make sure you do them slowly
Abdullah EjazGoogle review · Marrickville

Shown in full, as written on our Google Business Profiles.

Free quote

Tell us what you need.

Send us a few details and we'll get back to you with a clear, upfront quote.

Prefer to talk? Call 0421 772 661

Thanks, we've got it.We'll be in touch soon. For anything urgent, call 0421 772 661.
Call Now: 0421 772 661