BLUE LINK
Home · Electrical fault finding · Lights work, power points don't
Power loss fault diagnosis

Lights Work But Power Points Don't: What's Going On

Most Australian homes wire lighting and power points as separate circuits, each with its own breaker and often its own RCD. Lights still working while power points are dead almost always means the power-point circuit's breaker or safety switch has tripped specifically — not a general house-wide fault.

Check your switchboard for a tripped breaker or safety switch first. See why only half the house has power if it's more widespread than just power points.

Blue Link Electrical Services is a NSW licensed electrical contractor (licence 332956C), based in Marrickville, working across Sydney since 2016. Call 0421 772 661 if resetting it doesn't hold.

Licensed & insured
  • Licensed electrician, NSW 332956C
  • Working across Sydney since 2016

Why lights and power points fail independently

Separating lighting and power circuits is standard practice — it means a fault on one (say, a faulty appliance plugged into a power point) doesn't leave you in the dark too. So when power points go out but lights stay on, the fault is almost always isolated to that specific power circuit, not the house's incoming supply.

What to check first

When to call rather than keep resetting

If the breaker or safety switch won't hold even with everything unplugged, or it trips again as soon as something is plugged back in, that points to a wiring fault rather than a simple appliance overload — worth a proper fault-finding visit rather than repeated resets.

Frequently asked questions

Why would my house split lighting and power points onto different circuits?

So a fault on one doesn't take out the other — if an appliance causes a power-point circuit to trip, you're not also left without lighting.

What if I can't find a tripped switch at the switchboard?

It's possible a specific socket or section has its own isolated fault rather than a whole-circuit trip — this needs a proper electrical check rather than guesswork.

Is it safe to just use extension cords from a working room?

As a short-term workaround for a day, it's generally fine, but don't make it a long-term solution — overloading an extension cord or running one across walkways brings its own risks.

Could this affect my whole home eventually?

An isolated circuit fault usually stays isolated, but an underlying wiring issue can worsen over time — worth getting checked rather than living with it.

Need a licensed electrician?

0421 772 661

Blue Link Electrical Services · NSW licence 332956C · since 2016 · fully insured · 24/7 emergency

Blue Link Electrical Services · Marrickville NSW 2204 · 0421 772 661 · bluelinkelectrical.com.au

Call 0421 772 661