BLUE LINK
Home · Electrical fault finding · Power points work, lights don't
Power loss fault diagnosis

Power Points Work But Lights Don't: What's Going On

Since lighting and power points are normally separate circuits, power points staying on while lights go out points specifically to the lighting circuit's breaker or safety switch, or in some cases just a single switch or globe issue rather than a circuit-wide fault. Worth narrowing down which one before assuming the worst.

Check the switchboard for a tripped lighting circuit first. See why lights flicker if it's intermittent rather than fully out.

Blue Link Electrical Services is a NSW licensed electrical contractor (licence 332956C), based in Marrickville, working across Sydney since 2016. Call 0421 772 661 if it's more than one room or won't reset.

Licensed & insured
  • Licensed electrician, NSW 332956C
  • Working across Sydney since 2016

First, work out the scope

What to check at the switchboard

Look for a breaker or safety switch labelled for lighting that's in the "off" or tripped position. If it resets and holds, something briefly caused an overload or leakage (a dying globe or a faulty downlight driver can sometimes do this momentarily). If it won't hold, that's a wiring fault worth a proper check rather than repeated resets.

When it's not actually a circuit fault

If only one or two lights are out and everything else on that circuit works fine, it's more likely a specific globe, downlight driver, or switch rather than the circuit itself — see downlights not working after a bulb change if that matches your situation.

Frequently asked questions

Is it dangerous if only my lights have gone out?

Not typically an emergency on its own, but worth checking the switchboard rather than just replacing globes repeatedly if it keeps happening.

Why would a lighting circuit trip but not a power circuit?

Lighting circuits are separately protected specifically so a lighting fault doesn't take out your power points (and vice versa) — it's a deliberate design, not a coincidence.

Can a single faulty downlight trip the whole lighting circuit?

Yes, if its driver develops a short or significant leakage fault, it can trip the breaker or safety switch for the whole circuit it's on, not just that fitting.

What if resetting the switch works but it happens again later?

Repeated tripping even if it resets fine each time means something is still wrong — worth a proper check rather than waiting for it to fail at an inconvenient time.

Need a licensed electrician?

0421 772 661

Blue Link Electrical Services · NSW licence 332956C · since 2016 · fully insured · 24/7 emergency

Blue Link Electrical Services · Marrickville NSW 2204 · 0421 772 661 · bluelinkelectrical.com.au

Call 0421 772 661