BLUE LINK
Home · LED downlight installation · LED flicker when switched off
LED fault diagnosis

LED Lights Flickering or Glowing When Switched Off?

A faint glow or flicker from an "off" LED is almost always caused by a tiny leakage current still finding its way through the circuit — commonly from a switch with a neon indicator light, a dimmer switch's standby draw, or long cable runs with LED drivers sensitive enough to respond to it. It's not the LED itself failing.

If it's a smart switch specifically causing this, see our no-neutral smart switch guide or smart dimmer LED compatibility guide.

Blue Link Electrical Services is a NSW licensed electrical contractor (licence 332956C), based in Marrickville, working across Sydney since 2016. Call 0421 772 661 if it's bothering you — it's usually a quick, cheap fix.

Licensed & insured
  • Licensed electrician, NSW 332956C
  • Working across Sydney since 2016

Why "off" doesn't always mean zero current

LEDs need very little current to produce a visible glow, far less than an old incandescent bulb would ever respond to. That means tiny leakage currents that were always present in your wiring — but never visible with old-style globes — can be enough to make an LED glow or flicker faintly even with the switch off.

Common specific causes

What actually fixes it

Depending on the cause: swapping to a non-illuminated switch, fitting a small in-line capacitor/bypass designed for exactly this, or in some cases changing to a different LED driver less sensitive to leakage current. We identify the actual cause on site rather than guessing with a part swap.

Frequently asked questions

Is a glowing "off" LED dangerous?

No — it's a nuisance, not a safety issue. The leakage current involved is far too small to pose any risk.

Will replacing the LED bulb fix it?

Sometimes, if a different driver is less sensitive to the leakage — but it's often more reliable to fix the actual cause (the switch or wiring interaction) than to keep swapping bulbs.

Why didn't my old incandescent bulbs do this?

Incandescent bulbs need far more current to produce any visible light, so the same small leakage current that lights up an LED was always invisible with the old bulbs.

Does every LED do this?

No — it depends on the specific combination of switch, wiring, and driver sensitivity. Some setups never show it at all.

Need a licensed electrician?

0421 772 661

Blue Link Electrical Services · NSW licence 332956C · since 2016 · fully insured · 24/7 emergency

Blue Link Electrical Services · Marrickville NSW 2204 · 0421 772 661 · bluelinkelectrical.com.au

Call 0421 772 661