BLUE LINK
Home · Indoor lighting · LED strip voltage drop
LED strip technical guide

LED Strip Voltage Drop on Long Runs: Why It Happens

Low-voltage LED strips lose a small amount of voltage along their own length as current travels from the power feed point — over a long enough run, the far end receives noticeably less voltage than the near end, showing up as visibly dimmer or slightly colour-shifted LEDs toward the end of the strip. This is a real electrical phenomenon, not a faulty product.

See constant-voltage LED drivers for the related driver-sizing topic.

Blue Link Electrical Services is a NSW licensed electrical contractor (licence 332956C), based in Marrickville, fitting LED strip systems across Sydney since 2016. Call 0421 772 661 for a long run that stays even brightness throughout.

Licensed & insured
  • Licensed electrician, NSW 332956C
  • Working across Sydney since 2016

Why this happens

Every length of wire or conductor (including the thin copper traces inside an LED strip) has some resistance, which causes a small voltage loss over distance. On a short run, this is negligible. On a long run, especially at lower voltages like 12V, the accumulated loss becomes noticeable — the LEDs furthest from the power feed point receive less voltage and run visibly dimmer.

Ways to fix or avoid it

Why we calculate this before installing a long run

Knowing the run length upfront lets us plan the right approach (dual feed, higher voltage, injection points) before installation, rather than discovering visible dimming at the far end after everything's fitted and needing to retrofit a fix.

Frequently asked questions

How long can a run be before voltage drop becomes noticeable?

Depends on voltage, strip wattage per metre, and feed cable thickness — there's no single fixed distance; we calculate this for your specific setup.

Is this the same issue as flickering?

No — voltage drop causes gradual dimming/colour shift along the run's length, not flickering, which usually has a different cause like dimmer incompatibility.

Can I fix an existing installation with visible dimming at one end?

Often yes, by adding a feed point at the dim end or upgrading the feed cable — we can assess your existing setup.

Does 24V always avoid this problem?

Reduces it significantly for the same power delivered compared to 12V, but doesn't eliminate voltage drop entirely on very long runs.

Need a licensed electrician?

0421 772 661

Blue Link Electrical Services · NSW licence 332956C · since 2016 · fully insured · 24/7 emergency

Blue Link Electrical Services · Marrickville NSW 2204 · 0421 772 661 · bluelinkelectrical.com.au

Call 0421 772 661