BLUE LINK
Home · CCTV installation · PoE power budget explained
PoE network guide

PoE Power Budget Explained

A PoE switch has a total power budget — the maximum it can deliver across all connected devices combined, not an unlimited supply per port. Adding cameras one at a time, especially higher-draw models with heaters, IR illuminators, or pan-tilt motors, can eventually exceed that total budget even if each individual port is rated for enough power on paper.

See why PoE cameras go offline for the practical symptom this causes.

Blue Link Electrical Services is a NSW licensed electrical contractor (licence 332956C), based in Marrickville, fitting CCTV systems across Sydney since 2016. Call 0421 772 661 to plan your system's power budget properly from the start.

Licensed & insured
  • Licensed electrician, NSW 332956C
  • Working across Sydney since 2016

Why a per-port rating isn't the whole story

Each PoE port might be individually capable of delivering a certain amount of power, but the switch as a whole has a total power budget shared across all active ports. A switch with plenty of ports can still run out of total power capacity well before every port is individually maxed out, especially with higher-draw cameras.

What draws more power than a basic camera

Why this matters when planning or expanding a system

Adding cameras incrementally without checking the switch's remaining power budget is a common way systems end up with intermittent, hard-to-diagnose dropouts. We calculate total expected power draw against the switch's actual budget when planning a system, and again before adding more cameras to an existing one.

Frequently asked questions

How do I know my switch's total PoE power budget?

Check the switch's specification sheet — this is usually clearly listed as a total wattage figure, separate from each port's individual maximum.

Can I just add a second PoE switch if I run out of budget?

Yes, this is a common and reasonable solution for expanding beyond one switch's capacity.

Does every camera draw the same power?

No — basic cameras draw relatively little; cameras with heaters, strong IR illuminators, or motorised features draw meaningfully more.

Will exceeding the power budget damage my equipment?

Typically the switch protects itself by not delivering power beyond its capacity (causing dropouts) rather than damaging hardware, but it's still worth planning properly rather than relying on that safety margin.

Need a licensed electrician?

0421 772 661

Blue Link Electrical Services · NSW licence 332956C · since 2016 · fully insured · 24/7 emergency

Blue Link Electrical Services · Marrickville NSW 2204 · 0421 772 661 · bluelinkelectrical.com.au

Call 0421 772 661