Wall lights on the front pillars and facade of a two-storey house.
Wall lights on the front facade
Outdoor lighting makes paths, steps and entries safer at night and lets a yard or deck be used after dark. Fittings outside are exposed to rain, sun and, near the coast, salt, so the choice of fitting matters as much as where it goes.
Outdoor fittings and any outdoor power point must have an IP rating that suits their position, and every circuit supplying them needs RCD (safety switch) protection. Cable run underground must be the right type, at the right depth and marked or protected. Plug-in string lights should run from a weatherproof outdoor outlet, not an indoor lead. Once fixed wiring is finished, the work is tested and a Certificate of Compliance for Electrical Work (CCEW) is issued.
This two-storey Stanmore house has a dark brick lower level and rendered upper floor. Its front entry is flanked by two grey stone-clad pillars, each with an up-and-down wall light on its face, and more small lights sit under the eaves of the porch roof. A concrete path leads to the front door through a lawn.
Wall lights on masonry pillars need a cable route inside or behind the pillar. When the pillars are being built or clad, the cables can be run inside them, so each light point is ready when the cladding is finished.
Up-and-down lights wash the pillar both ways, highlighting the texture of the stone and lighting the path to the door. Matching fittings on each pillar keep the facade symmetrical at night.
Front entry lights are often put on a sensor or a timer, so the path is lit when someone arrives. The switching is chosen with the owner, and outdoor fittings are rated for the weather they will face.
Read about outdoor lighting and sensor lights, or see our Stanmore page. We are a licensed electrician (NSW 332956C), fully insured, with a lifetime warranty on our workmanship.
Yes. The cable runs inside or behind the pillar, ideally before the cladding goes on.
They light the wall above and below the fitting, highlighting texture and lighting the path.
Yes, with a sensor or timer, chosen to suit how you come and go.
Had a great experience with Blue Link Electrical in Stanmore. The team was friendly, reliable, and very professional. They arrived on time, explained everything clearly, and completed the job to a high standard. Would definitely use them again.
I liked the professional way of doing things, everything was thoroughly checked and the job was done to a very good standard.
Very positive experience with the electrical service,efficient work done,communication was excellent and neat and professional finish.
Shown in full, as written on our Google Business Profiles.
Send us a few details and we'll get back to you with a clear, upfront quote.