Daikin is one of the most common air conditioning brands in Sydney homes. Whoever installs the unit, it still needs a properly sized circuit, an isolator at the outdoor unit and a switchboard that can take the load. That electrical side is what we do.
Ring 0421 772 661 for a written quote. A photo of your switchboard and the Daikin model you've chosen lets us quote quickly.
A Daikin system has two halves: the indoor unit (a wall split, a cassette, or a ducted fan coil in the roof) and the outdoor condenser. The refrigeration technician mounts both, runs the pipework and handles the refrigerant. A licensed electrician supplies power to the system, fits the isolation and protection, and tests it.
Refrigerant work needs an ARC refrigerant handling licence, and that's not us. We work alongside your air conditioning installer, either before they arrive (so the circuit is ready) or alongside them on installation day, so the system can be commissioned without a second visit.
Blue Link Electrical is a licensed electrician based in Hurlstone Park (NSW Contractor Licence 332956C). We wire air conditioners across the Inner West and greater Sydney, in everything from Federation cottages to newer units.
Daikin is a Japanese manufacturer with a wide range in Australia: wall-mounted splits for single rooms, multi-split systems where one outdoor unit serves several indoor heads, and ducted systems for whole-house heating and cooling. The electrical needs vary a lot across that range, from a modest circuit for a small bedroom split to a much heavier supply for a large ducted unit, which may even be offered in single-phase or three-phase versions.
So we don't guess. Every Daikin unit comes with an installation manual that states the supply it needs, the recommended protection and where the power should connect. Send us the model name, or the manual itself, and we size the cable and breaker from that, then check your switchboard and main supply can carry it alongside everything else in the house.
Most fixed air conditioners need their own circuit from the switchboard. Our guide to air conditioner dedicated circuits explains why.
An isolating switch beside the outdoor unit lets the technician shut the system down safely for servicing. It needs to be rated for outdoor use and correctly sealed.
Cable size and breaker rating come from the unit's installation manual and the length of the cable run, not a rule of thumb.
The circuit is protected by an RCD, often as a combined RCBO so an air conditioner fault doesn't take out other circuits.
There needs to be room for a new circuit and enough spare capacity in the main supply. Old fuse boards usually need an upgrade first.
1. Plan with your installer. We confirm the Daikin model, where the outdoor and indoor units go, and whether the manual calls for power at the outdoor or indoor unit. Then we quote the circuit and cable route.
2. Rough-in. We run the cable from the switchboard to the unit location, often through the roof space or under the floor in older Inner West homes, and fit the new breaker or RCBO at the board.
3. Connect and isolate. Once the units are mounted, we fit the outdoor isolator and connect the supply to the terminals the manual specifies. The refrigeration technician then completes the pipework, evacuation and commissioning.
4. Test and certify. We test the circuit to AS/NZS 3000 and issue a Certificate of Compliance for Electrical Work. If something trips on first start, we're there to find out why.
Can be undersized protection, a loose connection, moisture in the isolator, or a fault in the unit itself. We test the circuit first; internal faults go to Daikin's service network.
Years of sun crack isolator covers and let water in, which causes trips after rain. See power tripping when it rains.
Older installations sometimes run an air conditioner off a general power circuit. It works until something else is switched on, then the breaker trips.
Common with older boards. Adding a circuit may mean replacing the board or adding a small sub-board.
No. Mounting the units, running pipework and handling refrigerant is done by an ARC-licensed refrigeration technician. We do the electrical supply, isolation, protection and testing.
Most fixed systems do, and the installation manual will say what it needs. A dedicated circuit also stops the air conditioner tripping when other appliances run.
It depends on the board and your main supply. A large ducted system draws heavily, so we check spare capacity and other big loads before quoting.
Yes. Sun-damaged isolators are a common cause of trips after rain, and replacing one is a straightforward job.
Yes. Blue Link Electrical holds NSW Electrical Contractor Licence 332956C, is fully insured, and issues a Certificate of Compliance for the work.
NSW Electrical Contractor Licence 332956C · Fully insured · Since 2016 · Based in Hurlstone Park
Excellent electrician Blue Link Electrical was honest, knowledgeable, and took the time to answer my questions The work was completed quickly without rushing and everything works perfectly Will be using them
Very professional and reliable service. Blue Link Electrical were punctual, friendly, and knew exactly what they were doing. The job was completed to a high standard and the place was left clean. Highly recommend to anyone needing electrical work.
Can't fault the service from Blue Link Electrical From first contact to job completion everything was smooth and professional Quality workmanship and great attention to detail. One of the best trades experiences I've had. Make sure you do them slowly
Shown in full, as written on our Google Business Profiles.
Send us a few details and we'll get back to you with a clear, upfront quote.