Home › Lighting & Power › Heirloom
Heirloom · Licence 332956C

Heirloom heated towel rail installation

Heirloom heated towel rails are often chosen as a design feature in renovated bathrooms. A clean, concealed connection keeps them looking the part. We install them across the Inner West and Sydney.

Ring 0421 772 661 for a quote. The earlier we're involved in a renovation, the neater the result.

Read what customers wrote, below
  • Licensed electrician, NSW 332956C
  • Based in Hurlstone Park
  • Written quote before work starts
Heirloom

Heirloom Heated towel rail installation.

Heirloom is an Australian brand known for heated towel rails in a range of shapes and finishes. In a bathroom where the tiles and tapware have been carefully chosen, the last thing you want is a cord dangling to a power point or a surface-mounted cable. That's why most of our towel rail work is planned during a renovation.

The electrical side is straightforward when the wall is open: a concealed connection point at the right height, a cable back to a switch or timer, and noggings in the wall so the rail can be fixed securely. Once the wall is tiled, retrofitting is still possible, but options become more limited.

Blue Link Electrical is a licensed electrician based in Hurlstone Park (NSW Contractor Licence 332956C). We work with homeowners, builders and tilers on bathroom electrics across the Inner West.

Know your model

Planning around the design.

Decide on the exact rail before rough-in. Different rails have different connection points and mounting positions, and the concealed outlet needs to line up with the rail's connection. The installation instructions show where it should sit. Bring the specification sheet to your electrician and tiler so everyone works from the same measurements.

Think about control too. A wall switch is simple, a timer warms towels before you need them, and some rails offer their own controls. Position the control outside the restricted areas around the bath and shower, and check the rail's IP rating suits where it'll be mounted. It's also a good time to plan the exhaust fan and heat lamp wiring.

Before we install

What the installation needs.

!

Exact connection position

Concealed outlets must line up with the rail. We set them out from the spec sheet.

!

Zone-aware placement

Rails and controls must suit their position relative to the bath and shower under AS/NZS 3000.

!

Structural fixing

Noggings or masonry fixings so the rail stays solid.

!

RCD protection

Bathroom circuits need safety switch protection. We check your board.

!

Control choice

Switch, timer or built-in control, located where it's practical and compliant.

How it works

How we install it.

1. Coordinate. We review the rail spec with you and the tiler and confirm positions.

2. Rough-in. We install cable, the concealed connection and the switch or timer position, with fixing points in place.

3. Fit-off. After tiling and waterproofing, we mount the rail, connect it and install the control.

4. Test and certify. We test to AS/NZS 3000 and provide a Certificate of Compliance for Electrical Work where required. See lighting and power.

Common problems

Common Heirloom problems.

!

Outlet in the wrong spot

Rough-in done before the rail was chosen. Coordinating early prevents it.

!

No warmth

Check the switch and timer settings first. If the supply is fine, it's a rail fault for the manufacturer.

!

Tripping safety switch

Moisture at the connection or a faulty element. See safety switch keeps tripping.

!

Retrofit in a tiled wall

Harder but often possible, depending on the wall and what's behind it.

Questions

Heirloom Heated towel rail: common questions.

When should the electrician be involved in a bathroom renovation?

Before waterproofing and tiling, so cables and concealed connections are in the right place.

Can a heated towel rail have a timer?

Yes. A timer is a practical way to warm towels and control running time.

Does the rail need its own circuit?

Heated towel rails are low power and usually go on an existing circuit, but we check capacity and protection.

Do you supply Heirloom rails?

We install them. Choose your rail and we'll quote the electrical work.

Are you licensed?

Yes. NSW Electrical Contractor Licence 332956C, fully insured.

More

Related brands and services.

Other brands we install
Related services and guides
Areas

Need a Heirloom heated towel rail installed?

0421 772 661

NSW Electrical Contractor Licence 332956C · Fully insured · Since 2016 · Based in Hurlstone Park

Google reviews

What customers wrote

Excellent electrician Blue Link Electrical was honest, knowledgeable, and took the time to answer my questions The work was completed quickly without rushing and everything works perfectly Will be using them
Parveen EjazGoogle review · Marrickville
Very professional and reliable service. Blue Link Electrical were punctual, friendly, and knew exactly what they were doing. The job was completed to a high standard and the place was left clean. Highly recommend to anyone needing electrical work.
Ablish MughalGoogle review · Marrickville
Can't fault the service from Blue Link Electrical From first contact to job completion everything was smooth and professional Quality workmanship and great attention to detail. One of the best trades experiences I've had. Make sure you do them slowly
Abdullah EjazGoogle review · Marrickville

Shown in full, as written on our Google Business Profiles.

Free quote

Tell us what you need.

Send us a few details and we'll get back to you with a clear, upfront quote.

Prefer to talk? Call 0421 772 661

Thanks, we've got it.We'll be in touch soon. For anything urgent, call 0421 772 661.
Call Now: 0421 772 661